user manual

Part Number 91-007-02
8
4.2 Interfaces
4.2.1 Configuring The Wireless Interface
The configuration screen for the wireless interface is shown below. The actual wireless interface is provisioned and
configured by the wireless Network Operator. SkyRouter’s Wireless Interface Configuration screen is used to establish
inactivity timeouts and Name Server selections.
Figure 6
Network Select
– This pull down menu allows the user to control the home network setting of the CDMA connection,
effectively limiting the scope of the Preferred Roaming List (PRL) assigned by your wireless network operator. There are
four possible settings:
1) Auto – Auto is the standard mode of operation and should continue to be used in most cases. In the Auto mode
of network selection the entire PRL is considered for serving network connections.
2) Home Only – In Home Only mode serving network connection choices are limited to those defined as Home in
the PRL.