Operation Manual

36
Safety InstructionsTracker Management by SMS
36
Reading Commands
Command Meaning and Values Example
rpos Read instantaneous GPS position data.
The tracker can reply in 3 different ways:
A) POS: <position data> = GPS position in real
time.
B) LAST POS: <position data> = no GPS signal. The
reply message contains the last detected GPS data.
C) POS: NO GPS DATA = from the tracker switching
on, the GPS signal has not been detected.
NOTE: the date and time refer to:
SMS sending, in case of Reply A•
last detected GPS data, in case of Reply B•
Command: rpos
Reply A:
POS:41g37.8283N,012g28.8191E,
ALT:0262m,DIR:023g,SPEED:0050km/h,
SAT:09,07/05/26,15:56
Reply B:
LAST POS:45g37.8283N,
008g28.8191E,ALT:0262m,
DIR:023g,SPEED:0050km/h,
SAT:09,07/05/26,15:56
Reply C:
POS: NO GPS DATA
Description:
41g37.8283N Lat. in degree, min.
012g28.8191E Long. in degree, min.
0262m Altitude in m
023g Direction in degree
0050km/h Speed in km/h
09 Satellites number
07/05/26 Date (yymmdd)
15:56 Time (hhmm)
rposc Read cyclic position SMS setup and power save
mode status.
[status: 0=disabled, 1=enabled]
[rate: 01÷99 minutes]
[power save mode: 0=disabled, 1=enabled]
Command: rposc
Reply: rposc=1,01,0
Description:
1=enabled cyclic position SMS
01=1 minute rate
0=disabled power save mode