Operation Manual

42
Reading and Writing SMS Commands
Writing Commands
Command Meaning and Values Example
wposc Set the cyclic position SMS in text format and the
relevant power save mode.
[enabling: 0=disable, 1=enable]
[rate: 01÷99 minutes]
[power save mode: 0=disable, 1=enable]
NOTE: the power save mode works only with
SMS rate5 minutes.
Never set like this: wposc=0,xx,1
NOTE: to enable or disable only the cyclic position
SMS, send the wposc command with the fi rst
fi eld only. In this case, the previously set rate is
considered.
Case A
Command: wposc=1,01,0
Reply: wposc=1,01,0 OK
Description:
1=enables the cyclic position SMS
01=1 minute rate
0=disables the power save mode
Case B
Command: wposc=1
Reply: wposc=1 OK
Description:
1=enables the cyclic position SMS with
the previous set rate
wms Set the accelerometer values.
[sensitivity: 00=disables sensor, 01=maximum,
10=minimum]
[timeout: 01÷99 minutes]
Command: wms=02,10
Reply: wms=02,10 OK
Description:
02=sensitivity level 2
10=10 minutes timeout
wem Erase all position data recorded in the memory. Command: wem
Reply: wem OK