User manual

Chapter2. Hardware Installation

Chapter 2. Installation

This chapter shows the front panel and how to install the hardware.

2.1 Front Panel

Please see the side view below configure 2.1:

Front panel can be separated into five parts fron left to right:

(1) DIP switch

(2) RJ-45 connector for Ethernet

(3) LEDs for Ethernet

(4) LED for VDSL

(5) RJ-45 connector for VDSL

1. The RJ-45 is designed to connect to the Local Network with the Unshielded Twisted

Pair (UTP) cable. The LEDs on top of RJ-45 connector show the status below:

LED for

Ethernet



Blinking

{

Off

Activity Link UP Link Down

100Mbps 10Mbps

{

Full Duplex Half Duplex