User manual

Chapter 5. Configure via Console Port
5-34
XIII. Exit SMT
For exiting SMT without saving any configuration, you can use the exit
command to exit the SMT. Select exit and press [ENTER] or [RIGHT].
------------------------------------------------------------
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot the system
diag Diagnostic utility
admin Setup management features
upgrade Software upgrade
>> exit Quick system
------------------------------------------------------------
------------------------------------------------------------
Command: exit <CR>
Message: Please input the following information.
Do you want to disconnect? (y/n) : y
------------------------------------------------------------
After press [ENTER], the SMT will be disconnected.