User manual

Chapter 5. Configure via Console Port
5-23
VII. Write the Setup Parameter
After configuration, write the new configured parameters into NVRAM
and reboot the SHDSL NTU to work with new parameters. Follow the
procedure;
Step 1: In main menu, move the cursor to write and press [ENTER].
--------------------------------------------------------------
setup Configure system
status Show running system status
show View system configuration
>> write Update flash configuration
reboot Reset and boot the system
diag Diagnostic utility
admin Setup management features
upgrade Software upgrade
exit Quick system
--------------------------------------------------------------
Step 2: Type “y” to write the new parameters
---------------------------------------------------------------
Command: write <CR>
Message: Please input the following information.
Are you sure? (y/n): y
---------------------------------------------------------