User manual

Chapter 5. Configure via Console Port
5-11
Configure SHDSL parameters
This section provide the setup for SHDSL parameters: Annex type,
margin, psd, wetting current, power backoff and framer.
Select SHDSL and press [ENTER] or [RIGHT].
--------------------------------------------------
type Configure shdsl type
>> shdsl Configure shdsl parameters
e1 Setup e1 parameters
default Restore factory default setting
For setting the SHDSL Annex type, move the cursor to annex and press
[ENTER]. Select the annex type by using [TAB] key.
--------------------------------------------------
>> annex Configure shdsl annex
margin Configure shdsl margin
psd Configure shdsl psd
pwr_backoff Configure power backoff
framer Configure shdsl framer
Command: setup shdsl annex <Annex_A|Annex_B>
Message: Please input the following information.
Annex Type (TAB Select) <Annex_A>: Annex_B
--------------------------------------------------------
For setting SHDSL Margin, move the cursor to margin and press [ENTER].
Select the startup margin via [TAB] key and key in the Next margin.
---------------------------------------------------
annex Configure shdsl annex
>> margin Configure shdsl margin
psd Configure shdsl psd
pwr_backoff Configure power backoff
framer Configure shdsl framer