User manual

Chapter 5. Configure via Console Port
5-9
VI. Configure the SHDSL NTU
This section provides information about configuring the SHDSL NTU.
Follow the procedures:
In main menu, select setup and press [ENTER] or [RIGHT].
--------------------------------------------------
>>
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot the system
diag Diagnostic utility
admin Setup management features
upgrade Software upgrade
exit Quick system
--------------------------------------------------
The screen will prompt as follows
-------------------------------------------
>>
type Configure shdsl type
shdsl Configure shdsl parameters
e1 Setup e1 parameters
default Restore factory default setting
--------------------------------------------