User manual

3.5.6. Application of STU-R configuration follow STU-C

Some configurations on STU-R side can follow STU-C side after DSL link up is finish.

Such that on STU-R side, you do not care about the settings of the E1 channel/slot number/first slot, serial data rate or

Ethernet data rate. When the DSL link up is finished, these configurations will follow the STU-C side.

STU-R STU-C

# If STU-C is as T1 interface and set T1 channel is unframed mode, STU-R cannot follow.

# When E1/T1 model time slot and Serial/Ethernet model date rate set 1 of 2 on STU-C side, STU-R cannot follow.

# For the application on multi-interface, this function is not available. User must setup the configuration for both as the same

time before DSL link.

E1 Interface

E1 Channel

E1 Slot Number

E1 First Slot

Serial Interface

Serial Data Rate

Ethernet Interface

Ethernet Data Rate