User manual

42
3.5.4. Sub-menu tree for SETUP Ethernet Interface
SYSTEM SETUP Î SET UP ETHERNET
If you set Ethernet Auto Negotiation to Enable, the default setting for Duplex is Full and Speed is 100M.
If you set Ethernet Auto Negotiation to Enable, the Duplex and Speed cannot be set up and it will use auto negotiation per
IEEE802.3u.
Ethernet Items Setting
T1 mode
Annex A/B 1 ~ 36
2-wires
Annex F/G 1 ~ 89
Annex A/B 2 ~ 72 (even number only)
Rate
Nx64K mode
4-wires
Annex F/G 2 ~ 178 (even number only)
Auto Disable Enable
Duplex
Full-Duplex
Half-Duplex
Auto
Configuration
Speed
100M
10M
Auto
Configuration
Note:
When SHDSL.bis uses 2-pairs(4-wires), the Nx64(Rate) number can only use even numbers.
When other side is T1 interface and unframed mode connects to this side as Ethernet interface, we must set Ethernet rate as
T1 mode.