Specifications

73
Command Description:
Command Description
enable
Modify command privilege. When you login via serial console or Telnet, the
EFM modem defaults to a program execution (read-only) privileges to you.
To change the configuration and write changes to nonvolatile RAM
(NVRAM), you must work in enable mode.
setup To configure the product, you have to use the setup command.
status View the status of product.
show Show the system and configuration of product.
write
Update flash configuration. After you have completed all necessary setting,
make sure to write the new configuration to NVRAM by "write" command
and reboot the system, or all of your changes will not take effect.
reboot Reset and boot system. After you have completed all necessary setting,
make sure to write the new configuration to NVRAM and reboot the system
by "reboot" command, or all of your changes will not take effect.
ping Internet Ping command.
admin You can setup management features in this command.
utility Upgrade software and backup and restore configuration are working via
"utility" command.
exit Quit system