Specifications

72
4.3 Enable
To setup the EFM modem, move the cursor " >>" to enable and press enter key. When the
screen appears, type the supervisor password. The default supervisor password is "root". The
password will be displayed as " * " symbol for system security.
-----------------
----------------------------------
----------------------------------------------------------------------
----------------------------------------------------------------------------------------------------------
-----------------------------------------------------
Command: enable <CR>
Command: enable <CR>Command: enable <CR>
Command: enable <CR>
Message: Please input the following information.
Message: Please input the following information.Message: Please input the following information.
Message: Please input the following information.
Supervisor password:
Supervisor password: Supervisor password:
Supervisor password: ****
********
****
----------------------------------------------------------------------
--------------------------------------------------------------------------------------------------------------------------------------------
----------------------------------------------------------------------
In this sub menu, you can setup management features and upgrade software, backup the
system configuration and restore the system configuration via utility tools.
For any changes of configuration, you have to write the new configuration to NVRAM and
reboot the EFM modem to run with the new settings.
The screen will display as follows.
>> enable Modify command privilege
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot system
ping Packet internet groper command
admin Setup management features
utility TFTP upgrade utility
exit Quit system