Specifications

67
4 Configuration use Serial Console and Telnet with Menu
Driven Interface
4.1 Introduction
4.1.1 Login to the Console Interface
The console port is a RJ-45 connector that enables a connection to a PC for monitoring and
configuring the EFM modem. Use the supplied serial cable with a female DB-9 connector to
serial port of PC and RJ-45 module jack connector to EFM modem’s console port. Start your
terminal access program by terminal emulation program or Hyper Terminal and configure its
communication parameters to match the following default characteristics of the console port:
Parameter Value
Baud rate 9600
Data Bits 8
Parity Check None
Stop Bits 1
Flow-control None
After finishing the parameter settings, press the SPACE key until the login screen appears.
When you see the login screen, you can logon to this EFM Modem.
Note: Only SPACE key invoke the login prompt. Pressing other keys will not work.
The system asks for User and Password, please enter "admin" both for the factory default
username and password.
User: admin
Password: *****
4.1.2 Telnet login
The EFM modem also supports Telnet protocol for remote management.
Make sure the correct Ethernet cable is connected the MGMT port of EFM modem to your
computer. The MGMT indicator on the front panel shall light if a correct cable is used. Start
your Telnet client with VT100 terminal emulation and connecting to the management IP of EFM
modem, wait for the login prompt to appear. Input User and Password after login screen pop
up. The system asks for User and Password, please enter "admin" for both username and
password.