Specifications

17
2.2.4 Power connection
Make sure you are using the correct power source for the AC/DC adaptor. Inset the female end
of power adaptor’s cord into the power receptacle on the rear panel. Connect the power
adaptor to an appropriate AC power source.
2.2.5 Reset Button
The reset button can be used in one of two ways.
(1) Press the Reset Button for two seconds will cause system reboot.
(2) Pressing the Reset Button for eight seconds will cause the product to load the factory
default settings, losing all of your set configuration. When you want to change the modem's
configuration but forgot the user name or password, or if the product is having problems
connecting to the Internet and you want to configure it again clearing all configurations, press
the Reset Button for eight seconds with a paper clip or sharp pencil.
2.2.6 Protective Earth (Frame Ground) terminal
The marked lug or terminal should be connected to the building protective earth bus.
The function of protective earth does not serve the purpose of providing protection against
electrical shock, but instead enhances surge suppression on the DSL lines for installations
where suitable bonding facilities exist.
The connector type is M3 machine screw.