Product specifications

72
Setup Ethernet Parameter, Speed
You can set up the Ethernet speed as 10Mbps or 100Mbps.
Duplex Mismatch issues
When using forced mode Ethernet, be sure that both devices on the Ethernet cable are set to the same
forced mode speed and duplex. Do not connect a forced mode Ethernet device to an auto negotiation device
unless you set the forced mode device to half duplex. This is because when an auto negotiation device fails
negotiation, it assumes a half duplex mode. This is the standard behavior defined in IEEE 802.3u.
4.5.6 Enable and Disable Remote configuration
You can set the “Enable/Disable Remote Config Capability” so that the remote side can receive configuration
parameters remotely.