User manual

Chapter 6. Status
6-6
CPE side
Click ROUTE and CPE Side then press
Next.
Type LAN parameters:
IP Address: 192.168.10.1
Subnet Mask: 255.255.255.0
Host Name: SOHO
DHCP Service: For more DHCP
service, review DHCP Service.
Type the Wan Parameters;
VPI: 0
VCI: 32
AAL5 Encap: LLC
Protocol: IPoA , EoA , IPoA + NAT or
EoA + NAT
Note: The Protocol used in CO and
CPE have to be the same.
Click Next to setup the IP parameters.
For more understanding of NAT, review
the NAT/DMZ section in this manual.
IP Address: 192.168.30.2
Subnet mask: 255.255.255.0
Gateway: 192.169.30.1
Click Next
The screen will prompt with the parameters that will be written in Flash. Check the parameters
before writing to Flash. Press Restart to restart the router working with new parameters or press
continue to setup another parameter.
Congratulation! You are done. Your SHDSL LAN-to-LAN connection is established.