User manual

89
Set the active interface number via interface command.
You can configure the global port number by using port command.
The local server, host, IP address and port number are configured via server command.
The authorized access protocol is setup via protocol command.
Name command can be used to configure the service name of the host server.
Begin and end command is used to setup the local server schedule to access.
You can view the fixed NAT mapping entry via list command.
14.16.12 DMZ
To setup demilitarized zone, move the cursor “>>” to dmz and press enter.
>> active Tigger DMZ host function
address Configure virtual IP address and interface
You can enable the demilitarized zone via active command.
After enabling the DMZ, shift the cursor to address and press enter.
----------------------------------------------------------------------
Command: setup ip_share dmz address <ip> <1~10>
Message: Please input the following information.
Virtual IP address: 192.168.0.251
Active interface number (Enter for default) <1>: 1
----------------------------------------------------------------------
14.16.13 Firewall
The product supports advanced firewall. To setup the advanced firewall, you can use firewall to
configure.
>> Level Configure firewall security level
pkt_filter Configure packet filter
dos_protection Configure DoS protection