User manual

88
You can create up to 10 fixed NAT mapping entry via range command.
----------------------------------------------------------------------
Command: setup ip_share nat fixed modify <1~1o> <ip> <ip>
Message: Please input the following information.
Fixed NAT mapping entry number <1~10>: 1
Local address: 192.168.0.250
Global address: 122.22.22.2
----------------------------------------------------------------------
After configuration fixed IP address entry, you can bind the entry to specific interface via interface
command.
----------------------------------------------------------------------
Command: setup ip_share nat fixed interface <1~5> <1~8>
Message: Please input the following information.
Fixed NAT mapping entry number <1~5>: 1
Active interface number (Enter for default) <1~8>: 1
----------------------------------------------------------------------
You can delete fixed NAT mapping entry- from 1 to 5- by using delete command.
You can view the fixed NAT mapping entry via list command.
14.16.11 PAT
To configure Port Address Translation, move the cursor “>>” to pat and press enter.
>> clear Clear virtual server mapping
modify Modify virtual server mapping
list Show virtual server mapping pool
You can delete virtual server mapping entry- from 1 to 10- by using clear command.
You can create up to 10 virtual server mapping entry via modify command.
----------------------------------------------------------------------
Command: setup ip_share pat modify <1~10>
Message: Please input the following information.
Virtual server entry number <1~10>: 1
----------------------------------------------------------------------
After key in enter, the screen will prompt as below.
>> interface Active interface
port TCP/UDP port number
server Host IP address and port number
protocol Transport protocol
name Service name
begin The schedule of beginning time
end The schedule of ending time