User manual

82
minutes.
Most of the ISP use dynamic IP for PPP connection but some of the ISP use static IP. Configure the IP
type, dynamic or fixed, via ip_type command.
You can review the WAN interface configuration via list command.
14.16.4 Bridge
You can setup the bridge parameters in bridge command. If the product is configured as a router, you
do not want to setup the bridge parameters. Move the cursor “ >> “ to
bridge and press enter.
>> gateway Default gateway
static Static bridging table
You can setup default gateway IP via gateway command.
You can setup 20 sets of static bridge in static command. After entering static menu, the screen will
prompt as below:
>> add Add static MAC entry
delete Delete static MAC entry
modify Modify static MAC entry
list Show static bridging table
After enter add menu, the screen will prompt as follow
>> mac Configure MAC address
lan_port Configure LAN interface bridging type
wan1_port Configure WAN1 interface bridging type
wan2_port Configure WAN2 interface bridging type
wan3_port Configure WAN3 interface bridging type
wan4_port Configure WAN4 interface bridging type
wan5_port Configure WAN5 interface bridging type
wan6_port Configure WAN6 interface bridging type
wan7_port Configure WAN7 interface bridging type
wan8_port Configure WAN8 interface bridging type
list Show static bridging table