User manual

80
14.16 Setup
All of the setup parameters are located in the subdirectories of setup. Move the cursor “ >> “ to setup
and press enter.
>> mode Switch system operation mode
shdsl.bis Configure SHDSL.bis parameters
wan Configure WAN interface profile
bridge Configure transparent bridging
vlan Configure virtual LAN paramters
route Configure routing parameters
lan Configure LAN interface profile
ip_share Configure NAT/PAT parameters
firewall Configure Firewall parameters
dhcp Configure DHCP parameters
dns_proxy Configure DNS proxy parameters
hostname Configure local host name
default Restore factory default setting
14.16.1 Mode
The product can act as routing mode or bridging mode. The default setting is routing mode. You can
change the system operation mode by using mode command. Move the cursor “ >> “ to mode and
press enter.
----------------------------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
----------------------------------------------------------------------
14.16.2 SHDSL.bis
You can setup the SHDSL.bis parameters by the command shdsl.bis. Move the cursor “ >> “ to
shdsl.bis and press enter.
>> mode Configure SHDSL.bis mode
n*64 Configure SHDSL.bis data rate
type Configure SHDSL.bis annex type
clear Clear current CRC error count
margin Configure SHDSL.bis SNR margin
There are two types of SHDSL.bis mode, STU-R and STU-C. STU-R means the terminal of central
office and STU-C customer premise equipment.
You can setup the data rate by the multiple of 64Kbps where n is from 3 to 89.
There are four types of SHDSL.bis Annex type, Annex-A, Annex-B, Annex-F, and Annex-G.
Clear command can clear CRC error count.