User manual

75
14.13 Administration
You can modify the user profile, telnet access, SNMP (Sample Network Management Protocol),
supervisor information and SNTP (Simple Network Time Protocol) in admin. The route is enable Î
admin.
For configuration the parameters, move the cursor “ >> “ to admin and press enter.
>> user Manage user profile
security Setup system security
snmp Configure SNMP parameter
passwd Change supervisor password
id Change supervisor ID
sntp Configure time synchronization
14.13.1 User Profile
You can use user command to clear, modify and list the user profile. You can setup at most five users
to access the router via console port or telnet in user profile table however users who have the
supervisor password can change the configuration of the router. Move the cursor “ >> “ to user and
press enter key.
>> clear Clear user profile
modify Modify the user profile
list
List the user profile
You can delete the user by number using clear command. If you do not make sure the number of user,
you can use list command to check it. Modify command is to modify an old user information or add a
new user to user profile.
To modify or add a new user, move the cursor to modify and press enter.
----------------------------------------------------------------------
Command: admin user modify <1~5> <more...>
Message: Please input the following information.
Legal access user profile number <1~5> : 2
----------------------------------------------------------------------
The screen will prompt as follow.
>> Attrib UI mode
Profile User name and password
There are two UI mode, command and menu mode, to setup the product. We will not discuss command
mode in this manual.