User manual

IP Address: 192.168.20.1

Subnet Mask: 255.255.255.0

Gateway: 192.169.30.2

Click Next

The screen will prompt the parameters that

we will write in EPROM. Check the

parameters before writing in EPROM.

Press Restart to restart the router working

with new parameters or press continue to setup another parameter.

13.2 CPE side

Click ROUTE and CPE Side then press

Next.

Type LAN parameters:

IP Address: 192.168.10.1

Subnet Mask: 255.255.255.0

Host Name: SOHO

DHCP Service: Disable or Enable

For more DHCP service, review DHCP

Service on page

30..

Type the WAN Parameters;

VPI: 0

VCI: 32

AAL5 Encap: LLC

Protocol: IPoA , EoA , IPoA + NAT or EoA +

NAT

Note: The Protocol used in CO and CPE

have to be the same.

Click Next to setup the IP parameters.

For more understanding about NAT, review

NAT/DMZ on page

44.

IP Address: 192.168.30.2