User manual

63
13 LAN to LAN Connection with Routing Mode
IP: 192.168.20.1
Netmask: 255.255.255.0
STU-C (CO)
STU-R (CPE)
Router
IP: 192.168.20.100
Netmask: 255.255.255.0
Gateway: 192.168.20.1
Router
IP: 192.168.10.1
Netmask: 255.255.255.0
IPoA or EoA
VPI:0, VCI:32
Encapsulation: LLC
IP: 192.168.10.200
Netmask: 255.255.255.0
Gateway: 192.168.10.1
IP: 192.168.30.1
Netmask: 255.255.255.0
Gateway: 192.168.30.2
IP: 192.168.30.2
Netmask: 255.255.255.0
Gateway: 192.168.30.1
13.1 CO Side
Click ROUTE and CO Side, then Next.
Type LAN parameters:
IP Address: 192.168.20.1
Subnet Mask: 255.255.255.0
Host Name: SOHO
Tigger DHCP Service: Disable or Enable
For more DHCP service, review DHCP
Service on page
30.
Type the WAN1 Parameters;
VPI: 0
VCI: 32
AAL5 Encap: LLC
Protocol: IPoA , EoA , IPoA + NAT or EoA
+ NAT
Note: The Protocol used in CO and CPE
must be the same.
Click Next to setup the IP parameters.
For more understanding about NAT, review
NAT/DMZ on page
44.