User manual

55
Configured 0.0.0.0 will allow all hosts on
Internet or LAN to access the router.
Leaving blank of trust host list will cause
blocking all PC from WAN to access the router.
On the other hand, only PC in LAN can
access the router.
If you type the excact IP address in the filed,
only the host can access the router.
Click Finish to finish the setting.
The browser will prompt the configured parameters and check it before writing into EPROM.
Press Restart to restart the gateway working with the new parameters and press Continue to setup
other parameters.
9.2 SNMP
Simple Network Management Protocol (SNMP) provides for the exchange of
messages between a network management client and a network management
agent for remote management of network nodes. These messages contain
requests to get and set variables that exist in network nodes in order to obtain
statistics, set configuration parameters, and monitor network events. SNMP
communications can occur over the LAN or WAN connection.
The router can generate SNMP traps to indicate alarm conditions, and it relies
on SNMP community strings to implement SNMP security.
This router support MIB I and MIB II.
Click SNMP to configure the parameters.
In the table of current community pool, you can setup
the access authority.
In the table of current trap host pool, you can setup
the trap host.
Press Modify to modify the community pool.