User manual

28
7 Basic Setup
The Basic Setup contains LAN, WAN, Bridge and Route operation mode.
User can use it to completely setup the router. After successfully
completing it, you can access Internet. This is the easiest and possible
way to setup the router.
Note: The advanced functions are only for advanced users to setup
advanced functions. The uncorrect setting of advanced function will
affect the performance or system error, even disconnection.
Click Basic for basic installation.
7.1 Bridge Mode
PC
IP: 192.168.0.2
Netmask: 255.255.255.0
Gateway: 192.168.0.254
VPI:0, VCI:32
Encapsulation: LLC
DSLAM
ISP
Bridge BAS
IP: 192.168.0.1
Netmask: 255.255.255.0
Gateway: 192.168.0.254
IP: 192.168.0.254
Before configuration the router in bridge mode check with
your ISP about this information.
Click Bridge and CPE Side to setup Bridging
mode of the Router and then click Next for
the next setting.
This product can be setup as two SHDSL.bis
working mode: CO (Central Office) and CPE
(Customer Premises Equipment). For
connection with DSLAM, the SHDSL.bis
working mode is CPE. For LAN to LAN
connection, one side must be CO and the
other side must be CPE.
VPI:
VCI:
Encapsulation:
Gateway:
Host Name:(if applicable)