Product specifications

Chapter 3 Configuration and Operation
18
3.10 Factory Default Scripts
When delivered from the factory, the units are paired as CO and CPE for immediate point-to-point use, with
all 4 E1s enabled, unframed, and LAN enabled. Because these units operate at Ethernet Layer 2, we address
the remotely connected pseudowire by MAC address.
If the device sticker has been lost, or if the MAC address has been inadvertently changed, the MAC for both
the MNT port and WAN port can be viewed through the CLI. Below is an example.
3.10.1 Determine Device MAC Address
CLI>m 4321
====== CLI: MW Test Functions ======
m 4321 OUI(xx:xx:xx)
===== Config: HW/SW MAC = 1 (HW_MAC).
===== Config: OUI-Addr = 00:02:AB.
===== Config: eth0 Addr = 00:02:AB:16:CD:13. <== this is NMS MAC Source
===== Config: eth1 Addr = 00:02:AB:16:CD:12. <== this is WAN MAC Source
3.10.2 CO Unit Factory Default Script
CO default, replace xx:xx:xx with CPE unit’s unique MAC Address
gci
srcnet 172.16.1.1 255.255.255.0
ipset 192.168.1.11 255.255.255.0 172.16.1.2
ceschset 1 1 172.16.1.2 00:02:AB:xx:xx:xx
ceschset 2 1 172.16.1.2 00:02:AB:xx:xx:xx
ceschset 3 1 172.16.1.2 00:02:AB:xx:xx:xx
ceschset 4 1 172.16.1.2 00:02:AB:xx:xx:xx
cespwidset 1 1 1
cespwidset 2 2 2
cespwidset 3 3 3
cespwidset 4 4 4
pktsize 1 0
pktsize 2 0
pktsize 3 0
pktsize 4 0
jitterbd 1 1
jitterbd 2 1
jitterbd 3 1
jitterbd 4 1
ceschclkset 1 2
ceschclkset 2 2
ceschclkset 3 2
ceschclkset 4 2
lanset 1 7
csave