User manual

 Alarm
 Motion Detection: Click it on for using Motion Detection function as a sensor.
You can set motion detection function at the motion detection function page.
Note: You can set motion detection at motion detection page. (Please go “Setting
→ Advance → Motion detection → Setting”) For more details, you can check
Chapter 6.6.
Note：
：：
： Motion Detection works only when the MPEG4 function is On.
 Parameter: the parameter of CGI (defined in URL of HTTP →
General) is from your target device. For example, move=down.
 Message: message will show up in the form of Message = PTZ down.
If your target device didn’t support the parameter of message, you
can’t see the message. So you can just take the message as a note.