Product specifications

FSW-2104W Multimedia Residential Gateway

Chapter 3: Connecting to Router

3.1 System Requirements

• Broadband Internet Access Service (FTTx)

• One single mode fiber connection using dual fiber or single fiber (WDM)

• Each PC on the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45 connectors

• TCP/IP protocol must be installed on each PC

3.2 Installation Environment Requirements

• Not in direct sunlight or near a heater or heating vent

• Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all sides of the router

• Well ventilated (especially if it is in a closet)

• Operating temperature: 0°~40°C (32°~104°F)

• Operating Humidity: 10%~90%RH, Non-condensing

3.3 Connecting the Router

Please install the router according to the following steps.

Please pull out the power plug and keep your hands dry.

Steps:

1. Power off your PC(s) and the router.

2. Connect the PC(s) and all Switches/Hubs on your LAN to the LAN Ports on the router.

3. Connect the fiber from provider to fiber WAN port on the router.

4. Connect the AC power adapter to the AC power socket on the router, and the other side into an electrical

outlet. The router will start to work automatically.

5. Power on your PC(s) and Cable/DSL modem.

Chapter 4: Fast Installation and Configuration

This chapter describes how to configure the basic functions of your FSW-2104W Cable/DSL router. You may

access the Internet via the router immediately after it has been successfully configured.

4.1 TCP/IP Configuration

• The default IP address of the FSW-2104W Cable/DSL Router is 192.168.123.211, and the default Subnet

Mask is 255.255.255.0. These values can be seen from the LAN, and can be changed as your desire.

• Connect the local PCs to the LAN ports on the router. There are then two means to configure the IP address

for your PCs.

• Configure the IP address manually

1) Set up the TCP/IP Protocol for your PC(s).

2) Configure the network parameters. The IP address is 192.168.123.xxx ("xxx" is from 1 to 254 except 211),

Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.211(The router's default IP address)

• Obtain an IP address automatically

1) Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on

your PC(s).

2) Power off the router and PC(s). Then turn on the router, and restart the PC(s).

The built-in DHCP server will assign IP addresses for the PC(s).You can run the Ping command in the

command prompt to verify the network connection between your PC(s) and the router.

The following example is under Windows XP environment:

Open a command prompt, and type ping 192.168.123.252, press Enter.