Specifications

Chapter 3 Web Based Management
3.2.6.14 Reset All Line Cards
The reset all line cards function will
do a warm reboot of all line cards
installed and recognized in the 220A. To
reset the cards, the “Yes” button must
be clicked.
3.2.6.15 All Line Cards Set to Factory Default
The set all line cards to factory
default function will return each installed
card to its original factory default
settings. To default the cards, the “Yes”
button must be clicked.
3.2.7 Switch
The L2 switch functions are
controlled under the Switch tab. There
are three categories, Ports, Aggregation
and VLAN.
3.2.7.1 Ports
The ‘Ports State Overview’ screen will display the link status for all ports of the L2 switch. The indicators 1~20
refer to the CH20 slots 1~20, as viewed from the front of the chassis, numbered from left to right.
Ports 21~24 are 10/100/1000 Base-T ports available at the rear of the CH20 chassis, located on the
GSW/SNMP plug-in card. The additional ports 25~28 are SFP optical based and may be 1000Base-FX or 2500-FX.
When using 2.5G optics, these four optical ports may be aggregated to 10G for any compatible 4x2500 switch.
Port status is indicated by color: Black means no link, Yellow is a link at 100M and Green is a link at 1G.
3.2.7.2 SFP
The SFP tab will display the parts MSA information plus DDOM (Optical Monitor) for supported SFP modules.
27