Specifications

ManualsBrandsCTC Union ManualsNetworkingFRM220-100M

100

Appendix A

A.8.5 Provisioning by NMC (Telnet)

When placed in the CH20 with NMC, this card can be configured through any of the NMC interfaces, including Telnet, Web

GUI and SNMP.

<1> : Port Active - Use this item to enable or disable the line card. When disabled all transmission will be blocked and all

the line card LED indicators will be Off.

<2> : Receive Side Setting - This will bring up the sub menu (see below) for setting these specific parameters.

<3> : Transmit Side Setting - This will bring up the sub menu (see below) for setting these specific parameters.

<4> : Auto Laser Shutdown (ALS) - Enables or disables the ALS safety feature for the Optical port.

<5> : Data Port Control Settings - These are the handshaking and polarity settings (menu on next page).

<6> : Loop Back Settings - There is support for loop back of both DATA signal and optical. Refer to the next page.

<7> : Data Port Mode Setting - Selects between DCE (RxD is output) or DTE (TxD is output) mode.

<8> : Data Port Interface Setting - This sets the electrical interface to RS-530 (X.21, RS-449), V.35 or RS-232.

<9> : Port Reset - This function will clear and reload the CPLD, effectively resetting the port. Data loss will occur when

performing this reset. Use with care.

<A> : Set to Default - This action will return the DATA card to factory default settings.

<D> : Go to Line Card Status menu - If an SFP is installed for optical, the information can be viewed here. See next page.

<N> : Go to the Remote menu - This device supports remote in-band management via Embedded Operations Channel.

Receive Side Setting Menu

Select the group rate and timing source for the receive clock.

Transmit Side Setting Menu

Select the group rate and timing source for the transmit clock.

This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]

SLOT #16 > FRM220-DATAPORT [Local ] [ Ver:1.000-1.050-1.010-0.000 ]

<1> :Port Active:[Enable ]

RD State:[Off ] TD State:[Off ] RTS State:[Off] CTS State:[on ]

DCD State:[on ] DSR State:[on ] DTR State:[Off ] RLB

State:[Off ]

LLB State:[Off ] TM State:[Off ]

FX Link :[Up ] FX Signal:[Yes] FX FEF:[Off ]

<2>: Receive Side Setting. <3>: Transmit Side Setting.

<4>: Auto Laser Shutdown(ALS):[Disable]

<5>: Data Port Control Setting:

<6>: Loop Back Setting:[Off ]

<7>: Data Port Mode Setting:[DCE Mode]

<8>: Data Port Interface Setting:[V.35 ]

<9>: Port Reset. <A>: Set to Default.

Small Form Pluggable(SFP):[No ] Digital Diagnostic(D/D):[No ]

<D>: Go to Line Card Status menu.

<N>: Go to the Remote menu.

------------------------------------------------------------------------

Receive Side Setting:

<0> : Receive Data Rate & Group : [Group1: 256K]

<1> : Receive Timing Source : [Recovery from remote transmit Side]

------------------------------------------------------------------------

Transmit Side Setting:

<0> : Transmit Data Rate & Group : [Group1: 256K]

<1> : Transmit Timing Source : [Same as Receive Timing Source ]

------------------------------------------------------------------------