Specifications

Appendix A

<1> : Port Active: The port can be disabled so that no traffic will pass. The default is with port enabled.

<2> : Negotiation: The default is ‘Auto’ per 802.3u. Set to ‘Manual’ to configure forced mode

<3> : Speed : The UTP supports 10, 100, 1000 speed setting if negotiation is set to manual.

<4> : Duplex : The UTP supports Full or Half Duplex setting if negotiation is set to manual.

<5> : Rate Limit Mode : Used in conjunction with IRL and ERL settings, this item enables or disables rate limiting.

<6> : Ingress Rate Limit : Provides pre-set limits to incoming packets. Must be enabled with item 2.

<7> : Egress Rate Limit : Provides pre-set limits to outgoing packets. Must be enabled with item 2.]

<5> : Device Information and Settings.

<1> : Device Active: Use this to completely disable the device and stop all transmissions.

<2> : Operation Mode: This toggles between 4-port switch mode and the Port VLAN mode.

<3> : Auto Laser Shutdown 1 (ALS1): Enable ALS for Fiber port 1

<4> : Auto Laser Shutdown 2 (ALS2): Enable ALS for Fiber Port 2

<5> : Link Fault Pass Through 1 (LFP1): Enable LFP for UTP port 3

<6> : Link Fault Pass Through 1 (LFP2): Enable LFP for UTP port 4

<6> : RMON IN/OUT Counters Information.

<7> : Clear all RMON Counters.

<8> : Device Reset : This function will reset the switch and will cause some traffic loss until the unit recovers.

<9> : Set to Default : This will return the unit to factory default settings.

---------------------------------------------------------------------------

Egress Rate Limit:

<0>:Disable <1>:250M <2>:140M <3>: 95M <4>: 57M <5>: 40M

<6>: 31M <7>: 25M <8>: 20M <9>: 14M <A>: 10M <B>: 8M

<C>: 6M <D>: 4M <E>: 3M <F>: 2M <G>: 1M <H>:960K

<I>:896K <J>:832K <K>:768K <L>:705K <M>:640K <N>:576K

<O>:512K <P>:448K <Q>:384K <R>:320K <S>:256K <T>:192K

<U>:128K <V>: 70K

<<< Device Information >>>

<1> : Device Active:[Enable ]

<2> : Operation Mode:[Switch Mode ]

<3> : Auto Laser Shutdown 1 (ALS1): [Disable]

<4> : Auto Laser Shutdown 2 (ALS2): [Disable]

<5> : Link Fault Pass Through 1 (LFP1): [Disable]

<6> : Link Fault Pass Through 1 (LFP2): [Disable]

<<< RMON In/Out Counters >>>

Fiber 1 In :[ 0] Byte

Fiber 1 Out :[ 0] Byte

Fiber 2 In :[ 0] Byte

Fiber 2 Out :[ 0] Byte

UTP 3 In :[ 0] Byte

UTP 3 Out :[ 0] Byte

UTP 4 In :[ 0] Byte

UTP 4 Out :[ 0] Byte