Specifications
Appendix A
72
Description of Menu Settings
<1> : Fiber 1 Displays information and settings for Port 1 fiber.
<2> : Fiber 2 Displays information and settings for Port 2 fiber.
<1> : Port Active: The port can be disabled so that no traffic will pass. The default is with port enabled.
<2> : Rate Limit Mode: Used in conjunction with IRL and ERL settings, this item enables or disables rate limiting.
<3> : IRL or ingress rate limit provides pre-set limits to incoming packets. Must be enabled with item 2.
<4> : ERL or egress rate limit provides pre-set limits to outgoing packets. Must be enabled with item 2.
<D> : Line card Status will display the SFP information and DD if SFP supports.
<3> : UTP 3 Displays information and settings for Port 3 UTP.
<4> : UTP 4 Displays information and settings for Port 4 UTP.
This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]
SLOT #09 > FRM220-1000EDS [Local ] [ Ver:1.200-1.600-0.000-0.000 ]
<<< Fiber 1 Information >>>
<1> : Port Active:[Enable ]
Link:[Down] FEF:[Off ] Speed:[1000]
Rx Active:[Off] Remote Power:[Ok ]
<2> : Rate Limit Mode :[Unlimited]
<3> : Ingress Rate Limit :[Disable]
<4> : Egress Rate Limit :[Disable]
Small Form Pluggable(SFP):[Yes] Digital Diagnostic(D/D):[No ]
<D> : Go to the Line Card Status.
---------------------------------------------------------------------------
Ingress Rate Limit :
<0>:Disable <1>:250M <2>:140M <3>: 95M <4>: 57M <5>: 40M
<6>: 31M <7>: 25M <8>: 20M <9>: 14M <A>: 10M <B>: 8M
<C>: 6M <D>: 4M <E>: 3M <F>: 2M <G>: 1M <H>:960K
<I>:896K <J>:832K <K>:768K <L>:705K <M>:640K <N>:576K
<O>:512K <P>:448K <Q>:384K <R>:320K <S>:256K <T>:192K
<U>:128K <V>: 70K
Vendor Name :[ FIBERXON INC. ]
Vendor Part Number:[ FTM-3125C-L40 ]
Fiber Type :[ Single ]
Wave Length :[ 1310nm ]
Wave Length 2 :[ ----nm ]
Link Length :[ 0040km ]
Tx Power :[ +01dBm ]
Rx Power :[ -40dBm ]
Temperature :[ +043C ]
Rx Sensitivity :[ ------ ]
Power Margin :[ ------ ]
Power Loss :[ -- dB ]
<<< UTP 3 Information >>>
<1> : Port Active:[Enable ] Link:[Down] Rx Active:[off]
<2> : Negotiation:[Auto ]
<3> : Speed :[10 ]
<4> : Duplex :[Half]
<5> : Rate Limit Mode :[Unlimited]
<6> : Ingress Rate Limit :[Disable]
<7> : Egress Rate Limit :[Disable]