Specifications

Appendix A
71
DIP SW 1 and DIP SW 2：
(note: 1000ES-1 has one DIP switch for its LAN 1 port only. SW5 has no function.)
(note2: 1000EDS has two DIP switches, DIPSW1 for LAN1 and DIPSW2 for LAN 2.)
ON LFP Enable
SW4
OFF LFP Disable
ON
2 pair channel mode
SW5
OFF
4 ports switch mode
DIP SW 1 (SW1~3) define the auto/forced port mode of Port 3, while DIP SW 2 (SW1~3) define the auto/forced mode of Port
4.
DIP SW1 (SW4) defines the LFP of Port 3, while DIP SW2 (SW4) defines the LFP of Port 4.
Use DIP SW1 (SW5) to select between 4 port switch mode and Port VLAN mode (dual converter). When this mode is selected,
the front panel LED labeled “2CH” will light, indicating the media converter is in the ‘two-channel’ mode.
DIP SW2 (SW5) is reserved and has no function
A.6.5 Provisioning by NMC (Telnet)
When placed in the CH20 with NMC, this card can be configured through any of the NMC interfaces, including Telnet, Web
GUI and SNMP.
SW 1 SW 2 SW 3 Mode of LAN Port
OFF OFF OFF UTP/NWAY (auto)
ON OFF OFF 1000/FULL (forced)
OFF ON OFF 100/FULL (forced)
OFF ON ON 100/HALF (forced)
ON ON OFF 10/FULL (forced)
ON ON ON 10/HALF (forced)
DIP SW 1 (SW5) dual mode
DIP SW 2 (SW5) not defined
This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]
SLOT #09 > FRM220-1000EDS [Local ] [ Ver:1.200-1.600-0.000-0.000 ]
<1> : Fiber 1 Information and Settings.
<2> : Fiber 2 Information and Settings.
<3> : UTP 3 Information and Settings.
<4> : UTP 4 Information and Settings.
<5> : Device Information and Settings.
<6> : RMON IN/OUT Counters Information.
<7> : Clear all RMON Counters.
<8> : Device Reset.
<9> : Set to Default.