Specifications

Appendix A
55
A.3.2 Block Diagram of 10/100i-2E
(For reference only)
A.3.3 FRM220-10/100i-2e Console Configuration
From the main menu of the FRM220 NMC console, select the slot number containing the 10/100i-2E line card.
This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]
SLOT #09 > FRM220-10/100I-2E [Local ] [ Ver:1.100-1.001-0.000-0.000 ]
<1>: Port Active:[Enable ]
<2>: UTP 1 Information and Settings.
<3>: UTP 2 Information and Settings.
FX Link:[Up ] FEF:[Off ] Remote PWR:[OK ]
<4>: Operation Mode: [Switch ]
<5>: Link Fault Pass Through(LFP): [Disable]
<6>: Auto Laser Shutdown(ALS): [Disable]
<7>: In Band Management:[Enable ]
<8>: Send Remote Hardware Reset
<9>: Port Reset
<A>: Set to default
Small Form Pluggable(SFP):[No ] Digital Diagnostic(D/D):[No ]
<D>: Go to Line Card Status menu. <N>:Go to the Remote menu.
Please select an item.
The chassis ID in a stacked set is shown on the first line.
The next line shows the slot number, card type, location and version. In this example the card's hardware version is 1.100 and
the firmware version is 1.001.
<1> When the port is disabled, the PHY becomes inactive and all Ethernet traffic will be blocked.
<2> <3> Select the information and settings for the two UTP ports.
Informational : Shows fiber link status, far end fault alarm and any dying gasp indication.
<4> Sets the operational mode between the default ‘switch’ mode or the special ‘Tag Based VLAN’ mode.
<5> Enables or disables the Link Fault Pass-Through (LFP) function
<6> Enables or disables the Auto Laser Shutdown (ALS) function.
<7> Enables or disables the OAM in-band management function.
<8> Send a hardware reset to remote unit via fiber (must enable reception from the remote side first)
<9> Performs a reset on the local switch port.
<A> Resets the card to factory default settings
Informational : If this is SFP model and SFP is installed, will indicate “Yes”. If SFP supports DD, will indicate “Yes”.
<D> View the transceiver's digital diagnostics (DD) if available. (only for SFP modules that support DD function)
<N> Go to manage the remote via OAM.
<ESC> Escape back to previous menu.
Switch
OAM
FIFO
MAC
MAC
μP
RS485 drive
r
Re
g
.
Edge Connector
12VDC
MII
LEDs
FX PHY Tx1
MAC
Card Face
Tx2
MAC