Specifications

Appendix A
45
Below is an example of managing the remote MC via OAM.
This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]
SLOT #02 > FRM220-10/100I [Remote] [ Ver:1.100-1.279-0.000-0.000 ]
Port Active:[Enable ]
UTP Link:[Up ] Rx Active:[On ]
<2>: Negotiation:[Auto ]
<3>: Speed: [100 ]
<4>: Duplex: [Full]
FX Link:[Up ] Rx Active:[On ] FEF:[Off ] Remote PWR:[OK ]
<5>: Loop Back Test:[Off ] Status:[----]
<6>: Operation Mode: [Switch ]
<7>: Ingress Rate Limit(IRL) Mode: [No Limit] [100.0M]
<8>: Egress Rate Limit(ERL) Mode: [No Limit] [100.0M]
<9>: Link Fault Pass Through(LFP): [Disable]
<A>: Auto Laser Shutdown(ALS): [Disable]
<B>: Accept Remote Hardware Reset: [Disable]
<C>: Port Reset <K>: Set to default
Small Form Pluggable(SFP):[No ] Digital Diagnostic(D/D) Function:[No]
<D>: Go to the D/D Functions menu. <N>: Go to the Local menu.
<ESC>: Go to previous menu. Please select an item.
When managing the remote converter, the port cannot be disabled. To do so would put it to sleep forever as it
cannot be awoken by any OAM command once the fiber is down. Therefore, no port disable option is provided in
the remote. It really is no problem as you can always disable the link from the CO side, which is preferred anyway.
A.1.4 FRM220-10/100i Web Based Configuration
Physical Slot number in CH20 >
Card Model >
Card Active when lit >
Fiber is linked when lit >
Remote has fault if lit >
UTP is linked if lit >
Ethernet is running Full Duplex >
Ethernet speed is 100M >
The above graphic represents a single slot in the FRM220. The entire chassis with all slots will be displayed in
the 'Local Display' view. Double click on any slot to go to the management page for that particular converter card.
A.1.4.1 Header
The header information shows the current chassis ID, Slot, Side, Type and Version.
Chassis ID
The chassis with management IP address is the first or ID zero chassis. From this NMC, up to 10 chassis may
be managed using only a single IP address. Chassis ID are numbered from zero to nine.