Specifications

Appendix A
162
A.27.4 Provision by DIP (Stand-alone)
FSW103 has no DIP. All provisioning stand-alone must be done through serial console when placed in CH01M
chassis.
A.27.5 Provision by Console Management
Place FSW103 in a CH01M and connect serial console cable. Set terminal for 38.4K, 8,N,1, and no flow control.
Operation
Select any of the menu items by keying in the menu item number or letter. Use the [ESC] to return to a
previous menu. Any setting is immediately applied to the transponder's circuitry. After all of the parameter settings
have been selected, go to the <D>Device Status and Configuration menu from the main menu and press <2>
Store Configuration to write the configuration in non-volatile RAM (NVR).
Explanation of Settings
<1,5,9>. LAN Service: This brings up the sub-menu to enable/disable the device’s port. When disabled, no traffic can go
through.
<2,6,A>. Negotiation: The default setting provides auto-negotiation per IEEE802.3u. Using this selection will bring up the
sub-menu to switch to manual mode setting.
<3,7,B>. Speed: This will bring up the sub-menu to set the speed to either 10M or 100M. This setting will not be applied
unless the negotiation is set to Manual.
<4,8,C> Duplex: This will bring up the sub-menu to set the duplex to either Full or Half. This setting will not be applied
unless the negotiation is set to Manual.
<D> Device Status and Configuration: This will bring up the sub-menu that includes disabling the entire device (all ports),
saving the configuration to NVR, restoring the factory default configuration, and resetting the switch.
<E> Fiber Status and Configuration: This will bring up the sub-menu specifically for the fiber interface. This includes
enabling or disabling Auto Laser Shutdown (ALS) and displaying the SFP information.
<P>. Password: Use this menu item to set the device login password to protect it from unauthorized access.
****************************************
*** CTC UNION TECHNOLOGIES CO.,LTD ***
*** FRM220A-FSW103 Manager Ver:1.0 ***
****************************************
Version:[1.00 -1.000-0.000-0.000] [ CH01M ]
<1> LAN 1 Service [ On ] Link [ Up ]
<2> Negotiation [ Auto ]
<3> Speed [ 100 ] Status[ 100 ]
<4> Duplex [ Full ] Status[ Full ]
<5> LAN 2 Service [ On ] Link [ Down ]
<6> Negotiation [ Auto ]
<7> Speed [ 100 ] Status[ 10 ]
<8> Duplex [ Full ] Status[ Half ]
<9> LAN 3 Service [ On ] Link [ Down ]
<A> Negotiation [ Auto ]
<B> Speed [ 100 ] Status[ 10 ]
<C> Duplex [ Full ] Status[ Half ]
<D> Device Status and Configuration
<E> Fiber Status and Configuration
<P> Setting Password