Specifications

Appendix A
161
A.27.1 Functional Details
FSW103 is a card based switch. The face has three 10/100Base electrical UTP and one SFP optical for
100Base-FX transceiver. The card’s golden header provides power and management from the Platform Chassis
and also has electrical Ethernet port which can be used by FRM220A-GSW/SNMP to aggregate Ethernet from all
installed cards.
FSW103 can be managed stand-alone when placed in single slot chassis with console port. When placed in a
managed chassis, all functions are controlled from the management card in the chassis. Any settings previously
done in stand-alone are overridden by management card.
A.27.2 Panel
|--------------------------- UTP Ports ----------------------------|----- FX Port -----
LED Color State Status
PWR (Green) On Power on
Off Power off or device disabled
Flash During firmware upgrade
FX (Green) On Fiber port link
Off Fiber port no link
On UTP port at 100M 100 (Green)
Off UTP port at 10M
LNK (Green) On UTP port link
Off UTP port no link
Flash UTP port link and active
A.27.3 Installation of SFP
CTC Union supplied SFP modules are of the Bale Clasp type. The bale clasp pluggable module has a bale
clasp that secures the module into the SFP cage.
A.27.3.1 Inserting a Bale Clasp SFP Module into the Cage
Step 1 Close the bale clasp upward before inserting the pluggable module.
Step 2 Line up the SFP module with the port, and slide it into the cage.
A.27.3.2 Removing a Bale Clasp SFP Module
Step 1 Open the bale clasp on the SFP module. Press the clasp downward with your index finger.
Step 2 Grasp the SFP module between your thumb and index finger and carefully remove it from the SFP cage.
Figure A.27.2 Bale Clasp type SFP with bale open