Specifications

Appendix A
129
A.13.4 Provisioning by NMC (Telnet)
When placed in the CH20 with NMC, this card can be configured through any of the NMC interfaces, including Telnet, Web
GUI and SNMP.
<1> : Port Active - Use this item to enable or disable the line card. When disabled all transmission will be blocked and all
the line card LED indicators will be Off.
<2> : Baud Rate Select - As a 3R repeater, the device needs to be set to the proper data rate for the intended application.
<3> : Loop Back Test - This initiates the sub-menu to select line side (top fiber connector), client side (bottom fiber
connector) or both line and client simultaneous loop back.
<4> : Loss Propagation - This enables or disables the Link Fault Passthru function of the converter.
<5> : Line Side Auto Laser Shutdown (ALS) - Enables or disables the ALS safety feature for the Line Side Optical port.
<6> : Client Side Auto Laser Shutdown (ALS) - Enables or disables the ALS safety feature for the Client Optical port.
<A> : Port Reset - This function will clear and reload the CPLD, effectively resetting the port. Data loss will occur when
performing this reset. Use with care.
<D> : Go to Line Card Status menu - If an SFP is installed for optical, the information can be viewed here. See below..
Line Card Status
This Chassis ID:[00] Cascaded:[Yes] Monitored Chassis ID:[00]
SLOT #10 > FRM220-3R/2.7G-3S [Local] [ Ver:1.100-1.009-1.100-0.000 ]
Line Status: [Up ] Primary Status: [Up ] Secondary Status:
[Down]
Line Tx Detect:[Normal] Primary Tx Detect:[Normal] Secondary Tx
Detect:[Normal]
<1> :Port Active:[Enable ]
<2> :Baud Rate Select:[Gigabit Ethernet]
<3> :Loopback Test Function: [Disable ]
<4> :Loss Propagation:[Disable]
<5> :Line Side Auto Laser Shutdown :[Disable]
<6> :Primary Side Auto Laser Shutdown :[Disable]
<7> :Secondary Side Auto Laser Shutdown:[Disable]
<8> :Optic Fiber Protection:[OFF]
<9> :Active Path :[Primary ]
<A> :Port Reset.
<D> :Go to Line Card Status menu.
SLOT #10 > FRM220-3R/2.7G-3S [Local ] [ Ver:1.100-1.009-1.100-0.000 ]
Vendor Name :[ FIBERXON INC. ]
Vendor Part Number:[ FTM-3125C-L40 ]
Fiber Type :[ Single ]
Wave Length :[ 1310nm ]
Wave Length 2 :[ ----nm ]
Link Length :[ 0040km ]
Tx Power :[ +01dBm ]
Rx Power :[ -22dBm ]
Temperature :[ +045C ]
Rx Sensitivity :[ ------ ]
Power Margin :[ ------ ]