User manual

Chapter 3. Installation
26 Version 1.2 Apr 2006
3.5.5 SNMP Feature Removal / Replacement
***CAUTION***
This procedure should only be performed by qualified service personnel. In addition, all
power connections must be removed before attempting to open the case.
1. If the unit is installed in a rack, it must be removed.
2. Follow the procedure in 3-5-3 to remove the top cover.
3. The connector for the SNMP daughter card is just behind the front panel display connector.
Carefully seat the card, ensuring no pins are bent. The three holes in the PCB should line up with
the three stand-offs on the mainboard.
4. Install the three pan-head screws supplied. Tighten firmly, but do not over tighten. Refer to
the photo below.
5. Re-install the top cover.
Figure 3-9 : SNMP daughter card Removal / Replacement