Product specifications

Chapter 5 Operation

5.6.4 Trunk Ethernet Parameter Config

The Trunk Ethernet Parameters Config screen will show the LAN1, LAN2 and SNMP management (M)

ports for both local (Lo) and remote (Re) multiplexers.

Each port can set an identifier reference "name", set the service mode, enable or disable auto-negotiation,

configure speed and duplex in forced mode (auto disabled) and enable or disable Ethernet flow control.

System Name: Trunk Ethernet Parameters Config

[F3]Site: All

+-----------------------------------------------------------------------------+

|[F1]St#/Pt# Serv Auto-Nego Duplex-Type Speed Flow-Ctrl Circuit Id |

|LAN/Lo/1 IS ON Full 100M OFF |

|LAN/Lo/2 IS ON Full 100M OFF |

|LAN/Lo/M IS ON Full 100M OFF |

|LAN/Re/1 IS ON Full 100M OFF #|

|LAN/Re/2 IS ON Full 100M OFF #|

|LAN/Re/M IS ON Full 100M OFF #|

| #|

+-----------------------------------------------------------------------------+

| Edit[F2] Group IS[F5] Group OOS[F6] Back[ESC] |

+-----------------------------------------------------------------------------+

System Name: Trunk Ethernet Parameters Slot Editing

Location : Local/Port 1

[F1] Circuit Identifier : __________________

[F3] Service Mode : IS

[F4] Auto-Negotiation : ON

[F5] Duplex Type : Full

[F6] Ethernet Speed : 100M

[F7] Flow Control : OFF

+-----------------------------------------------------------------------+

| Confirm[F2] Back[ESC] |

+-----------------------------------------------------------------------+