Product specifications

Chapter 3 Panel Description
12
Chapter 3 Panel Description
3.1 Front Panel
(1) Optical 1/2 : LSRON LED Yellow light when the laser is on
LOS LED Red light when there is a loss of optical signal
WK LED Working path indicator
RX Optical Receiver Port
TX Optical Transmitter Port
(2) LAN1/2 port : 100M full rate ports
(3) SNMP Port : RJ-45 connector to SNMP management system
(4) EXT CLK Port(Option) : External clock input; 2,048 MHz TTL CLOCK or E1 PCM
(5) Order Wire Port : Earphone and Microphone jack for order wire application
(6) CALL Button : Activate/deactivate the order wire
(7) ACO Button : Alarm Cut Off; Yellow light when the ACO button is pressed to manually
disable the audible alarm when a problem occurs. If any newer alarm is
reported after the ACO button has been pressed, the external alarm will
activate again.
(8) MAJ LED : Red light when there is a Major Alarm present
(9) MIN LED : Yellow LED lights when there is a Minor Alarm present
(10) LBK LED : Yellow LED lights when there is a loopback function presents.
(11) RDI LED : Remote Defect Indication;
Indicates a failure in the remote terminal
(12) PWR LED : Green LED lights when power module active.
(13) LCK LED : Optical link Lock; Locks the system if switched to protect line 6 times within
10 minutes
(14) RNG LED : Yellow LED lights when the order-wire function is active.
(15) ACO LED : Alarm Cut Off function indicator
(16) Console Port : For VT-100 screen setup
(17) RS232 : clear channel RS-232 data transmission and receive port.
(18) RST Button : Restart the system
(19) Push Buttons : Three control and configuration buttons for FMUX01A/Plus
TX RX
OE
LSRO
WK
LOS
Optical1
Optical2
TX RX
OE
LSRO
WK
LOS
LCK
ACO
MAJ PWR
MIN
RDI
CALL ACO
LBK RNG
1 2 3 4
1
11
1
2
22
2
3
33
3
4
44
4
CHANNELS
RST
EXT CLK
SNM
P
LAN2 LAN1
RS23
2
Consol
e