User manual

Chapter 3 Provisioning
34
3.2.13 User and Password Configuration
CTC Union's ET100R router provides two levels of management access: user and super-user. User access only
allows you to view the operating values; you cannot change any values. Super-user access gives you the power to view
and configure all of the router's operating parameters.
1. To create or change the password for the initial login to the ET100R.
CLI commands: (must be in enable)
config system password
Changing password for admin
Enter the new password
Enter new password: *****
Bad password: too simple.
Warning: weak password (continuing).
Re-enter new password: *****
Password changed.
Note: If the password length is under 8 characters, the system will flag it as being too simple of a password, but it will
still allow the password change. If the password is 8 or more characters there will be no such warning.
2. To create or change the password for the super-user or 'enable' password of the ET100R.
CLI commands: (must be in enable)
config system enable_password
Enter the new password:
New Password: ********
Re-confirmed: ********
If you forget either the user password or the super-user password, you must perform the hardware reset as described in
3.2.11.