Manualshelf

User manual

ManualsBrandsCTC Union ManualsComputer equipmentETU01C
21222324252627282930
Chapter 3 Provisioning
24
3. Local ET100R CLI commands.
System status check; System, Interface summary, Route table, System memory…
CLI Commands:
show config
show system
show memory
show interface summary
show ip route
Configure and Verify Local ET100R router module.
CLI commands: (must be in enable)
config system name Near
config ip rip off
config interface eth1 off
config interface eth1 ip 0 addr 192.168.1.254 netmask 255.255.255.0
config interface hdlc1 off
config interface hdlc1 encap ppp
config interface hdlc1 ip 0 addr 10.0.0.1 netmask 255.255.255.252
config ip route add net 0.0.0.0 netmask 0.0.0.0 gw 10.0.0.2 if hdlc1
config interface hdlc1 on
config interface eth1 on
config save
show interface summary
show ip route
Note: You may type configuration commands to a text file, copy them and paste them into HyperTerminal and it will
"run" similar to a run-config-script. Please refer to the scripts folder on the CDROM for many pre-written scripts.
4. Remote ET100R CLI commands.
System status check; System, Interface summary, Route table, System memory…
CLI Commands:
show config
show system
show memory
show interface summary
show ip route
Configure and Verify Remote ET100R router module.
CLI commands: (must be in enable)
config system name Remote
config ip rip off
config interface eth1 off
config interface eth1 ip 0 addr 192.168.0.254 netmask 255.255.255.0
config interface hdlc1 off
config interface hdlc1 encap ppp
config interface hdlc1 ip 0 addr 10.0.0.2 netmask 255.255.255.252
config ip route add net 0.0.0.0 netmask 0.0.0.0 gw 10.0.0.1 if hdlc1
config interface hdlc1 on
config interface eth1 on
config save
show interface summary
show ip route
ping 192.168.1.254 ---- This should be successful pinging to PC in LAN A
ping 10.0.0.1 ---- This should be successful pinging to WAN I/F in ET100R located in LAN A.
Note: You may type configuration commands to a text file, copy them and paste them into HyperTerminal and it will
"run" similar to a run-config-script. Please refer to the scripts folder on the CDROM for many pre-written scripts.