User manual

Chapter 3 Provisioning
19
Configure and Verify Remote ET100R router module.
CLI commands: (must be in enable)
config system name Remote
config ip rip off
config interface eth1 off
config interface eth1 ip 0 addr 192.168.0.254 netmask 255.255.255.0
config interface hdlc1 off
config interface hdlc1 encap cisco
config interface hdlc1 ip 0 addr 10.0.0.2 netmask 255.255.255.252
config ip route add net 0.0.0.0 netmask 0.0.0.0 gw 10.0.0.1 if hdlc1
config interface hdlc1 on
config interface eth1 on
config save
show interface summary
show ip route
ping 192.168.1.254 ---- This should be successful pinging to PC in LAN A
ping 10.0.0.1 ---- This should be successful pinging to WAN I/F in ET100R located in LAN A.
Note: You may type configuration commands to a text file, copy them and paste them into HyperTerminal and it will
"run" similar to a run-config-script. Please refer to the scripts folder on the CDROM for many pre-written scripts.
ET100R> enabl
e
Enter Password:
ET100R#
config system name remote
remote# config ip rip off
remote#
config interface eth1 off
remote#
config interface eth1 ip 0 addr 192.168.0.254 netmask
255.255.255.0
remote#
config interface hdlc1 off
remote#
config interface hdlc1 encap cisco
remote#
config interface hdlc1 ip 0 addr 10.0.0.2 netmask 255.255.255.252
remote#
config ip route add net 0.0.0.0 netmask 0.0.0.0 gw 10.0.0.1 if
hdlc1
remote#
config interface hdlc1 on
remote#
config interface eth1 on
remote#
config save
Saving configuration... Please wait!
Configuration saved.
(continued on next page)