User manual

Chapter 3 Provisioning

CISCO

YSTEMS

3.2 Applications

3.2.1 Cisco HDLC Encapsulation

3.2.1.1 Scenario

This is a typical application using CTC Union's ET100R with E1/T1 series access units or multiplexers. The

ET100R router module with Cisco HDLC WAN encapsulation enables you to access the Intranet or Internet resource

through Cisco routers or other ET100R in E1/T1 connection.

Figure 3-2: ET100R Point-to-Point Application with Cisco router

3.2.1.2 Preparation

Although this is a simple point-to-point application, you must deal with it very carefully. There are some reference

points to consider regarding this application.

• E1 or T1 connectivity establishment.

• IP addressing scheme and planning. (Table 3-1)

LAN A LAN IP Netmask WAN IP Netmask Peer IP

Network ID 192.168.1.0 255.255.255.0

PC 192.168.1.1 255.255.255.0

ET100R 192.168.1.254 255.255.255.0 10.0.0.1 255.255.255.252 10.0.0.2

LANB LAN IP Netmask WAN IP Netmask Peer IP

Network ID 192.168.0.0 255.255.255.0

PC 192.168.0.1 255.255.255.0

ET100R 192.168.0.254 255.255.255.0 10.0.0.2 255.255.255.252 10.0.0.1

Table 3-1 Address scheme and planning

• Routing protocol: Static route

• Encapsulation: Cisco HDLC

• Administration: System name, System information, Configuration check, Interface summary

• Deployment: CLI commands

3.2.1.3 Deployment procedures

1. E1 or T1 connectivity establishment.

Please refer to CTC Union's E1/T1 DSU/CSU product manual for further operation.

2. IP addressing setting: Configure static IP addresses in PCs on LAN A (local) and LAN B (remote).