Technical data

CTC EcoZenith i250

General Information

Important to remember!

Check the following points in particular at the time of delivery and installation:

• The product must be transported and stored in an upright position.

When moving the product, it can be placed temporarily on its back.

• Remove the packaging and check before installation that the product

has not been damaged in transit. Report any transport damage to the

carrier.

• Place the product on a solid foundation, preferably made of concrete.

If the product needs to be placed on a soft carpet, base plates

must be placed under the adjustable feet.

• Remember to leave a service area of at least 1 m in front of the

product.

• The product must not be placed below floor level either.

• On installation in a newly built dwelling, the regulations of the Swedish

National Board of Housing, Building and Planning (Boverket) must be

adhered to when setting maximum power output. The installer must key

in the four figure code 8818 under the menu: Service/Factory settings

coded, within one week – this locks maximum power.

Safety Instructions

The following safety instructions must be observed when handling, installing

and using the product:

• Close the safety switch before doing any work on the product.

• The product must not be flushed with water.

• When handling the product with a hoist ring or similar device, make

sure that the lifting equipment, eyebolts, etc. are not damaged. Never

stand under the hoisted product.

• Never jeopardize safety by removing bolted covers, hoods or similar.

• Never jeopardize safety by deactivating safety equipment.

• Any work done on the product’s electrical system should be done by a

qualified professional.

• Safety valve check:

- The safety valve for the boiler/system and domestic hot water (DHW)

must be checked on a regular basis. See the chapter on Operation and

maintenance.

If these instructions are not followed when installing, operating and maintaining

the system, Enertech’s commitment under the applicable warranty terms is not

binding