Technical data

CTC EcoZenith i250

Installation

11. Installation

This chapter is aimed at anyone responsible for one or more of the

installations required to ensure that the product works the way the property

owner wants.

Take your time going through functions and settings with the property owner

and answer any questions. Both you and the CTC EcoZenith i250 benefit

from a user who has completely understood how the system operates and

should be maintained.

11.1 Transportation

Transport the unit to the installation site before removing the packaging.

Handle the product in the following manner:

• Forklift

• Lifting eye that has been fitted to the lifting sleeve on top of the

EcoZenith i250. An extra sleeve can be found in the middle, under the

insulation.

• Lifting band around the pallet. NB: Can only be used with the

packaging on.

Remember that the CTC EcoZenith i250 has a high centre of gravity and

should be handled with caution.

11.2 Unpacking

Unpack the CTC EcoZenith i250 when it is placed next to its installation

site. Check that the product has not been damaged in transit. Report any

transport damage to the carrier. Also check that the delivery is complete

according to the list below.

11.3 Standard delivery

• CTC EcoZenith i250 system tank with factory-installed charge pump for

connection of heat pump.

• Kit bag containing:

– Installation and Maintenance Manual

– Outdoor sensor

– Room sensor

– Safety valve 9 bar (clean water)

– Sensor, 2 off (to and from pipes)

– Current sensor, 3 off

– 2 x cable ties

– Insulation EPP centre 41mm.

– Support sleeve 22x1 cu

The product must

be transported and

stored in an upright

position.