User manual

ATU-R130 ADSL Ethernet Router User’s Guide
22
2. In the USB Configuration table, enter the IP Address and Network Mask for the
USB port.
The IP address must place the USB port in the same subnet as the USB computer; If
you are using both the LAN port and the USB port, however, the USB port and USB
computer must not be in the same subnet as the LAN port or the computers attached to
it.
For example, you could assign the following IP addresses to the LAN and USB ports
(both assume a network mask of 255.255.255.0):
Port IP Address Computer(s) IP
Address(es)
LAN
192.168.1.1 192.168.1.x (x = 3-254)
USB
192.168.1.2 192.168.1.x
3. Click .
? If you are currently communicating with the device via the USB interface, then
the connection will be terminated, because the IP address that the connection
was using has now changed.
? If you are currently using the Ethernet interface, a page will display to confirm
your change and your connection will remain active.
4. If necessary, reconfigure your USB PC so that its IP address places it in the same
subnet as the new IP address of the USB port.
5. Log into Configuration Manager by typing the new USB port IP address in your
Web browser’s address/location box.
6. If the new settings work properly click the Admin tab, and then click Commit &
Reboot in the task bar.
7. Click to save your changes to permanent memory.