Network Router User Manual

ADSL IP DSLAM
15
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet location unless the jack is specially
designed for wet location.
• Never touch uninsulated telephone wires or terminals unless the telephone
line has been disconnected at the network interface.
• Use caution when installing or modifying telephone lines (other than a
cordless telephone) during an electrical storm. There is a remote risk of electric
shock from lightning.
• Do not use a telephone or other equipment connected to telephone lines to
report a gas leak in the vicinity of the leak.
ADSL IP DSLAM Rear Panel Connection
The following figure shows the rear panel connection of ADSL IP DSLAM:
Figure 2-1 ADSL IP DSLAM Rear Panel Connection
Step 1: Ground the ADSL IP DSLAM by connecting a grounded wire
Step 2: Connect the ADSL line connector, a 50-pin centronic connector, of
ADSL IP DSLAM to CPE by using telco cable. Each line connector supports 8
ports of ADSL for Data path from MDF(Main Distribution Frame).
Step 3: Connect the phone connector, a 50-pin centronic connector, of ADSL
IP DSLAM to Exchange/PBX by using telco cable. phone connector is an
optional module supporting Voice path to Exchange/PBX; it must be along with
Line Connector.
Step 4: Connect the power adapter and plug it into an outlet.