Instruction manual

CTA Instruction Manual MPE
Reference: MT0027DA This document may be modified without prior notice 18
Revision date: 11/05/06 Even partial reproduction is prohibited without authorisation in writing
13 Appendices
13.1 Use of a purge with a level detection function
Various risks (electrocution, explosion...): The following operations must only be carried out by
personnel qualified in electrical and pneumatic systems.
Before installation, the operations described in § 4.1 and 4.2 must be carried out.
After installation, the operations described in § 4.3 and 4.4 must be carried out.
Your Mastéria drier is pre-fitted for an external purge with a level detection system. To connect this type of
purge, you must:
1. Raise your drier sufficiently to enable the purge to be fitted underneath with creating a water pocket.
2. Remove the lower plug on the condensate separator.
3. To connect pipework to feed condensates to the external purge.
To use your external purge correctly, refer to the manufacturer's instructions.
4. Close the manual valve on the internal sequential purge.
This will inhibit the electronic board from opening and closing it.
Separator base
Dryer fitted with an external drain
!
Drain
Plug
Connection 1/2" F
Bodywork
Isolator